/**
* struct stedma40_platform_data - Configuration struct for the dma device.
*
- * @dev_tx: mapping between destination event line and io address
- * @dev_rx: mapping between source event line and io address
* @disabled_channels: A vector, ending with -1, that marks physical channels
* that are for different reasons not available for the driver.
* @soft_lli_chans: A vector, that marks physical channels will use LLI by SW
* which avoids HW bug that exists in some versions of the controller.
- * SoftLLI introduces relink overhead that could impact performace for
+ * SoftLLI introduces relink overhead that could impact performance for
* certain use cases.
* @num_of_soft_lli_chans: The number of channels that needs to be configured
* to use SoftLLI.
/*
* since 9540 and 8540 has the same HW revision
- * use v4a for 9540 or ealier
+ * use v4a for 9540 or earlier
* use v4b for 8540 or later
* HW revision:
* DB8500ed has revision 0
*
* @base: The virtual address of LCLA. 18 bit aligned.
* @dma_addr: DMA address, if mapped
- * @base_unaligned: The orignal kmalloc pointer, if kmalloc is used.
+ * @base_unaligned: The original kmalloc pointer, if kmalloc is used.
* This pointer is only there for clean-up on error.
* @pages: The number of pages needed for all physical channels.
* Only used later for clean-up on error
return;
check_pending_tx:
- /* Rescue manouver if receiving double interrupts */
+ /* Rescue maneuver if receiving double interrupts */
if (d40c->pending_tx > 0)
d40c->pending_tx--;
spin_unlock_irqrestore(&d40c->lock, flags);
base->lcla_pool.base = (void *)page_list[i];
} else {
/*
- * After many attempts and no succees with finding the correct
+ * After many attempts and no success with finding the correct
* alignment, try with allocating a big buffer.
*/
dev_warn(base->dev,